碳棍握把 Handle replacement for carbonstick

Sold in 1pair

价格为1对

更换指南 Replacement instructions: 

*仅适用于泡棉握把 For sponge handle*

1）将旧的握把割除，清理干净残余棍上的胶水。

Cut off old handle using blade/knife, clean any glue residue on stick.

2）用美工白胶从握把中间往下涂约10cm

Apply art white glue/polystyrene glue starting from middle of handstick 10cm towards down.

3）把新握把由上至下推入碳棍（注意握把方向），静置风干24小时后，如尾巴处有胶水残留，抠掉即可。Push in new handle(determine the correct direction of sponge) and let dry for 24hours. Remove glue residue at the end tip if any.

更换指南 Replacement instructions: 

*仅适用于PRO软胶握把 For PRO silicone handle*

1）将旧的握把割除，清理干净残余棍上的胶水。

Cut off old handle using blade/knife, clean any glue residue on stick.

2）在棍子上抹一点水，让新的握把更容易推入。

Sprinkle some water on handstick so that new handle can be insert in smoothly.

3）将握把头尾翻开约1cm，在里面均匀涂上一圈热熔胶，再翻回去即可。Flip down the top and bottom of handle outwards about 1cm, apply some hot glue inside evenly then flip the handle back. (热熔胶可以增加摩擦力，让握把不易脱落。Hot glue can increase friction and prevent handle from coming off)